I think that's because they are 'endless' but the controls within traktor aren't. got a mate with an apc and when he gets so far round it jumps back to start. mainly because it's (technically) not the right kind of encoder.
to make sure though, can you list up the settings you have for LED output on those?
controller & midi range min/max and invert/blend on or off?
can you describe the behaviour you're after? you just want it to light up solid colour when in loop?
Based on the description i'm guessing you're mapping an OUT for Loop size + set and have the controller range set wrong
(check out this LED guide i put up).
In the controller range you'll want the same number in both boxes and the numbers relate to the options in the IN dropdown box (where you set the loop size for the map).
IN List // OUT number
--- // -1
/32 // 0
/16 // 1
/8 // 2
/4 // 3
/2 // 4
1 // 5
2 // 6
4 // 7
8 // 8
16 // 9
32 // 10
so what ever loop size you're using that needs to be in both controller range min and max boxes.
however, if you then change your loop size while playing that'll mess the OUT up again, i'd recommend just setting an OUT for 'Loop Active'
set controller range min @ 0 max @ 1
uncheck invert and blend
and set the midi min and max to which colour/states you want for off and on
Off (0), Flashing Green (1), Green (2), Flashing Red (3), Red (4), Flashing Orange (5) and Orange (6).
Bookmarks