1) Perhaps I've missed this being discussed already, but why the does the 1.3 Firmware always default load to FX Bank B? and not A? Not that big of a deal.. but just wondering if there was some reasoning behind that.
2) Sometimes, while doing a mix session.. the right platter jog wheel (Deck B) will just STOP being able to sense or send out the Pitch down / Nudge controller data. Nudging up works fine, but Down will just stop. I've figured out that I can turn off the unit and power back on and it works again.
Is this a hardware issue or software?
I'm using the VCI-100SE_1_3_TT_Style.tks file, btw.
Bookmarks