My Maschine Maps itself..help?

[specialj88]

Hey Everyone,

Need a little help with mapping my Maschine to Traktor. I know how to map my functions just fine. But when I assign, let's say ( a hot cue to a pad) it will also loop even though I never assigned loop at all. Some functions just seem to map automatically. Even on others maps. This has been very frustrating. Please, some help. Thank-J

[padi_04]

Does this only happen with Mashcine?
Have you checked that you don't have any other mapping file loaded that might be conflicting with the new one? If so then disable the In/Out ports on the older one or if it's a different controller then check their I/O aren't set to listen to all controllers but the specific one you are targeting with that map.