Help setting up VCI-100SE - No channel faders/crossfader in software
Results 1 to 2 of 2
  1. 08-30-2011, 02:13 AM #1
    mikeTOOtall
    mikeTOOtall is offline
    Tech Student
    Join Date
    Aug 2011
    Posts
    4

    Default Help setting up VCI-100SE - No channel faders/crossfader in software

    I just bought a VCI-100SE second hand and am trying to set it up. I have installed Traktor Scratch Pro v1.2.4, and downloaded the v3.6.4 mappings, and imported the mapping into Traktor. All of the buttons, knobs and trackwheels work fine. The only problem I have is the ch 1/2 faders and crossfader are not mapped into the software. Even when I go to the "2D int Mixer" mode to see everything, there are no ch 1/2 faders that show up, and when I move the faders on the controller, they do nothing. Any ideas on why this is happening? Thanks!
    Reply With Quote Reply With Quote
  2. 08-30-2011, 02:21 AM #2
    mikeTOOtall
    mikeTOOtall is offline
    Tech Student
    Join Date
    Aug 2011
    Posts
    4

    Default

    NM - just figured it out from another post on here. I had to select "internal" from the audio Output Routing prefs....
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules
© 2023 DJTechTools