Is there a Template for vci 100 arcade buttons.

[IPM]

Hi

Just wondering. I was going to fit arcade buttons to my vci 100 se but I just realised, is there a template to drill the button holes in the right place because I was also going to buy the new vci 100 se mapping ovelay when it comes out, so how would I know if my button holes line up with the new mapping overlays button holes ?

all the best
IPM

[IPM]

does anyone know ?

[photojojo]

I've got one, but no guarantees I can find it. I know you can take the cad file and open it in illustrator. Maybe try one of the aviary suite tools to see if you can open it and save it as a pdf or something.

[basspenetrator]

you can wait until the overlay is out and do it like this
http://www.djtechtools.com/forum/showthread.php?t=8244

[IPM]

you can wait until the overlay is out and do it like this
http://www.djtechtools.com/forum/showthread.php?t=8244

Thank you for the link.

[IPM]

I've got one, but no guarantees I can find it. I know you can take the cad file and open it in illustrator. Maybe try one of the aviary suite tools to see if you can open it and save it as a pdf or something.

I have illustrator, would be greatly appreciated if you do find it.

all the best
IPM

[basspenetrator]

I have illustrator, would be greatly appreciated if you do find it.

all the best
IPM

http://www.djtechtools.com/2009/07/2...iy-arcade-mod/

[IPM]

Thank you weltraumpapst

I've watched the video a couple of times but have never seen the template.

all the best
IPM

[sarasin]

HOW DID IT GO!

I am guessing you either have not done it yet...or it was successful.

If it fucked out.....I am sure you woulda been back here in a SHOT!

[IPM]

Hi Sarasin

I haven't done it yet, for a couple of reasons:

I'm still deciding on which arcade buttons to go for at the moment (i have an idea of which ones), I'm also waiting on the new overlay being released. I'm not sure whether to go ahead just now and then fit the overlay when they come out or wait for the overlay and then go ahead.

I'm still trying to figure out the best way to go about this. I tried to download the template for cutting the holes but it doesn't seem to download it just takes you to a page of gobbledegook. Plus, according to the instructions, the overlay goes over the buttons, so I'm wondering, is it better to go for the regular overlay for normal buttons and cut the arcade button holes to the right size and that way the overlay will be under the overlap of the buttons. If that makes sense.

all the best
IPM