stupid question.

[kollision]

hello got the kit today to upgrade the firmware but i have a stupid question. what do you do with the kit after upgrading ? do you lave it attach to the pcb or you remove it ?
it sounds stupid but after updating, the video doesn t say anything.

[photojojo]

You remove it and make sure you plug the cable back in and put the cardboard piece back where it goes.

[kollision]

i replaced everything and when it switch it nothing happens.not even the light for the usb power. and the firmware upgraded successfully.

[photojojo]

Did you plug everything back in and double check the cardboard piece.

[kollision]

yes i put back the small cable, put back the screw of the pcb, the paper on top of it. put the bottom back (without screw) and tried. no light at all

[photojojo]

The screw on the back is part of the grounding system I believe.

[kollision]

even with all screws it doesn t work...sounds bad..

[fullenglishpint]

try reflashing, are you 100% sure it was successful and didn't just delete the old FW?

[kollision]

here is the log of the dev sotware after my update :

Clock Frequency (External) = 24.0000MHz, Clock Mode = 0, CKM = 1, and CKP = N/A
Connecting to device 'H8/3052F' on 'COM3'
Configuration:
'BOOT Mode' connection - using emulated interface
Opening port 'COM3' ...
Loading Comms DLL
Loaded Comms DLL
Initiating BOOT SCI sequence
Attempting 9600
Received immediate response from device: 0xAA
Using micro-Kernel : 'C:\Program Files (x86)\Renesas\FDT4.05\kernels\ProtB\3052\Renesas\1 _2_00\uGen3052.cde'
Downloading and verifying micro kernel...
Device is erasing...
Erase Timeout value set to 21 seconds
Erase Successful
micro-Kernel download successful
Sending inquiry for getting line size
Buffer size has been set to default (128 bytes)
Sending selection of device command
Selection of Device - Device selected, code 0302
Sending selection of clock mode
Sending selection of clock mode
Selection of Clock Mode - Clock selected, code 0
Changing baud rate to 38400 bps
Set baud rate value = 38400
Downloading main kernel 'C:\Program Files (x86)\Renesas\FDT4.05\kernels\ProtB\3052\Renesas\1 _2_00\Genm3052.cde'
Main kernel download complete...
Connection complete

[kollision]

then when i upload the file :

Opening file C:\Users\seb\Desktop\VCI100-DaveX-1.4.mot
File loaded: 0x00000000 -> 0x0007FFFF [User Flash]

Processing file :"C:\Users\seb\Desktop\VCI100-DaveX-1.4.mot"
Operation on User Flash
Downloaded the operation module
Writing image to device... [0x00000000 - 0x0000907F]
Writing image to device... [0x00009080 - 0x0000917F]
Writing image to device... [0x00009180 - 0x00009AFF]
Data programmed at the following positions:
0x00000000 - 0x0000907F Length : 0x00009080
0x00009080 - 0x0000917F Length : 0x00000100
0x00009180 - 0x00009AFF Length : 0x00000980
38.75 K programmed in 48 seconds
Image written to device