Midifighter Update for Mac OS X

[No Left Turn]

Worked perfectly. Thank you SO much for this! This is a godsend compared to how you had to update it before.

[Jergo]

everythingworks fine now i did the wire trick and it works fine. when i tried to update it again it went through everything normally however when i was prompted to enter boot mode i couldnt bc the MF was still stuck at that point so it just said failed to enter bootloader mode. however i was able to update this using the pc install and it worked fine.

[djstevievano]

Success!!!

[notshy]

Me too !!!

[Paulo]

Sorted!

[Fatlimey]

That's the sound I like to hear! Rockin'.

[doc country]

Perfecto!

[Systemattik]

Hi Fatlimey,

Unfortunately I could not open the app on my mac. I got the following error message : "The application cannot be opened as the file is not supported on this type of mac"

I have got the latest OSX update & run a 1st Gen Dualcore Macbook, so it should work on OSX versions 10.4 & above ? OSX Version 10.6.6

This App would be godsend as I have juggled bit upto now doing the firmware flashing on our very dodgy PC upstairs that barely starts up these days.....

Kind Regards,

Matti

We now have a version of Midifighter Update for Mac OS X, version 10.4 and up, downloadable from here:

http://www.djtechtools.com/software/mac/MFUpdate.dmg

Open the DMG file as usual and drag the app onto the Desktop or into your Applications folder before executing it (super important to run it outside of the DMG, it downloads a temporary file).

Try it out and report any successes or issues to this thread.

You're welcome.

[Fatlimey]

Hmm. Would this be an Intel-based Macbook?

[Systemattik]

Hi Mate,

It's an Intel Mac , somewhat a relic, but still runs sweet on Snow Leopard