I have my DDM 4000 set up so that the crossfader section (the bit with the midi bounce, the xfader curve etc.) is in midi mode. I then have a modifier set up so that the beat selector, both the LEDs and buttons (the bit on top with 1,2,4,8,16), choose which deck the lower buttons (midi bounce, reverse tap, reverse hold) affect. This is all set up fine however the problem I run into is that if I switch from deck A to deck B on the selector it will keep the LED feedback of deck A on the lower buttons. So how do I get traktor to update the LED feedback when I switch the modifier? Sorry if that was confusing.
Bookmarks