pitch faders question...

[tjay]

My pitch faders are set to 8%, but only register 1 - 2% on screen and only move incrementally on the screen when I adjust them on the controller.

Tried increasing Rotary Sensitivity to 100% per a forum suggestion. No go.

Any ideas?

Thanks.

Macbook Pro
Traktor 1.2.5
Vestax 100 SE (1.3 firmware)
VCI-1003_4.tsi

[pilmat]

Are all 4 "Tempo" in the TSI at 100%?

Phil.

[tjay]

Phil,
Thanks for the quick response... Yes, all 4 tempos are 100% in rotary sensitivity, 0% in acceleration.

Clues? - 1. "Device' setting always returns to Generic after I close and reopen the controller window. TSI settings remain when I pull up the Vestax default, but Generic is always what it goes back to.

2. Traktor randomly returns to a default status when it wants to. IE - browser settings, preferences etc.. No rhyme or reason.

Time for a clean install?

Thanks for the help.

Tom

[pilmat]

Don't worry about the generic, as long as your VCI is there and it's ports are set to Vestax and NOT all-ports that is not your issue.

I don't see how a clean install is going to solve anything, your running a Mac which tends not to suffer the same as Windows. I think it might just be you ports setting from above.

Try and let us know.

Phil.

[tjay]

Phil,

"VCI-100SE Generic MIDI (All Ports, All Ports)...

Perhaps I imported the TSI improperly?

Your response time is great, thanks.

Tom

[pilmat]

No, you imported properly, Traktor defaults to All-Ports... Just pick the Vestax off the drop down for both the in and out port and see if that sorts you out.

Don't feel bad about being a little confused, I recently forgot to set the ports and posted a "major bug" post on the official TSI thread. Yes I was embarrassed when I found MY error...

Phil.

[tjay]

Halfway home Phil... Deck A's slider works perfectly, Deck B is still only @ 2% (out of 8).

Double checked the tempo settings, all good. Both in and out ports are vestax.

Appreciate your patience and encouragement.

t.