Need Help!

[NateD]

So i think i have a problem with the sooundcard, I can't get the cue to start working,

so on monitor, left is out1. right is out2, on master left i on out3 and right is out4...

I have the numark dj io, the sound is crackling.... it has horrible sound quality...

[tekki]

Make sure you have the crossfader set correctly.

And crackling noise means your latency is set way too low. up the milliseconds.
Also check the operating instructions once again.

[JesC]

Hey Nate, just give me a call, I'll walk you thru the whole process, it should take about 20mins.

[NateD]

I'm running the traktor 3 demo.... can this be the issue?

Do i need to set all my knobs at neutral before i turn on my unit?

Can someone post steps of how they start up there setup ex. like open up traktor then what?

[JesC]

I would start the vci-100 in ver 1.2 so you can get used to it. you can do it by turning off the vci then turning it back on while holding the 2nd black button "loop b" on the upper left hand corner of the vci

[NateD]

so should i run traktor LE? i didnt install it, alli did was install traktor 3. So traktor le and 1.2 should fix my problems?

maybe boot in 1.3 and use traktor LE?