...
I know Arduino has some issues, I said "something like".
Maybe this?
http://overtone-labs.ning.com/
Arduino choice was for its great community but I'm dissapointed too with new arduino uno and non-standard shield pinout.
...
...
I know Arduino has some issues, I said "something like".
Maybe this?
http://overtone-labs.ning.com/
Arduino choice was for its great community but I'm dissapointed too with new arduino uno and non-standard shield pinout.
...
DJTT sent me a new PCB and how do I remove it to replace it?
Hello My friends seems as though my midi fighter pcb is not working
only the top left light is on
i followed all of these instructions
http://www.djtechtools.com/forum/showthread.php?t=16533
to no avail.
Any other ideas?
After overpowering (I think) my MidiFighter (and VCI) it is no longer alive. The LED's work fine (when i plug it in the LED's make a quick flash roll from top left to lower right) but i can't get it to send any midi-signals or get it to re-flash the firmware. It simply can't detect the MidiFighter either in normal- or boot mode.
I'm can't get the "Flip Atmel" to work, I don't think I'm tech-savvy enough.
13"MBP - VCI-100B - M-audio oxygen 8 - Maschine - Midi Fighter[DEAD] - Audio2Dj - KRK RP8
have you tried the wire method to get it into boot mode?
http://www.djtechtools.com/forum/showthread.php?t=17824
Only the (last) wire method worked for me to fix this problem.
I'm on a mac and used the MFUpdate DMG to flash with latest firmware after using a paperclip on the boot and reset terminal holes as described.
Is it likely that this problem will occur again or has the new firmware fixed it?
|
Bookmarks