Macbook Built in monitoring?! WOW!

[huggy]

i stall cant get this to work ? pls help what do you set the master out too ?

[HerbStrike]

i stall cant get this to work ? pls help what do you set the master out too ?

what are you using?

[huggy]

i have set my Audio midi Setup as above but im not sure what to set the system setttings properties for and the output should be set too ? with the clock set to the built-in audio in the structure window ? all the four aggregate are set in Trakordj but when i click play not a thing

[huggy]

for my sound card i have a novation remote 25 audio

my mac is a G5 dual 2 ghz with 10.5.8

Traktor 3.3.2

[HerbStrike]

right so in prefrence's you got you aggregate sound device selected as your main out i run it at 44100hz with a 11.5ms latency. then you go into output options and select internal mode you should have three options you only need monitor and master plug some speakers into your sound card and headphones into the Mac's in-built output then depending on which order you stated when you set up the aggregate device the two stereo audio channels will be 0 1 2 3. 0 and 1 together, 2 and 3 together then you should be able to test each ti find the monitor and the master. if that does not work then delete and and create a new aggregate device and try again

[huggy]

thank you so much for your reply herbstrike

[HerbStrike]

Did you get it to work in the end I was very intoxticated when I wrote that reply

[korona]

This has nothing to do with your computer being a Macbook, by the way.

[djmoonie]

I can't believe ppl are asking how to do this.

Honestly guys, its not rocket science..

To mono split the master and monitor from left and right signals just open the audio routing and...

Well.. surely you can figure it out from there!

[Mixer Miyagi]

Ha this is great. I knew about this but never tried because of my external soundcard. Well, that recently tanked and this works great. I like a mono signal anyways, considering I only use one of my cabs when practicing.