Originally Posted by
JCribb
I have been messing around with my APC40 for the last couple of days.
I am really struggling with the LED output. I understand the whole concept that the square pad buttons are momentary and that these buttons send themselves an LED off command of '0' after they are released.
I would like to be able to set up a pad to be a hotcue. When the APC40 first turns on, I would like it to be red. Then when I load a track, I would like it to turn green if there is a cue point saved on it. If there is no saved cue point, any subsequent pressing of this button will turn it green, since it is setting the cue point.
I tried using the Hotcue State, and this works great when you load the track, the cue will light up correctly. It's just that when you press it, the button goes dark on release, since it is sending itself that off message. Checking 'Invert' has no effect.
Has anyone been able to do this on their APC40?
Bookmarks