Traktor midi mapping - using a fader to turn on a button

[DJDeckstar]

Hi Folks, first post here and this one relates to a TCI file for the VCI 100 by DJTT.

I have a Pioneer Wego and running Traktor Pro 2.6, but I am trying to code/midi map the FX combo function seen on the VCI 100 mapping by DJTT, seen on this link:



I have pretty much done it, except for the last component, where the fader used to control the Button 2 and Knob 2 (the volume fader on the controller) finally turns on the Button 3 when in the bottom position. I have tried a few things but can't get it, including the 'invert' function and using the volume fader control as it's own modifier. Not having much luck. If anyone has any helpful hints would be greatly appreciated.

[Stewe]

There isn't a definitive answer for this as it all depends or resolution of the fader but yes, combining two commands (one hold, one direct) and inverting one of them can give the same result as in the VCI special firmware where this extra note is applied at the very end.

If you look at vid you'll notice that I have two echo-out effects mapped at each side end of the fader.

[synthet1c]

or you could just use VDJ Pro

effect slider 1 & param_equal 100% ? effect button 1 1 : effect button 1 0

[Stewe]

or you could just use VDJ Pro

effect slider 1 & param_equal 100% ? effect button 1 1 : effect button 1 0

Haha! Nice one syntet1c

Too bad the effects in VDJ are no mach to Traktor.

[synthet1c]

correct unless you use PC and VST's

[Stewe]

That part ain't VDJ though...

[synthet1c]

also correct

[Patch]

Too bad the effects in VDJ are no mach to Traktor.

correct unless you use PC and VST's

I like VDJ fanboys, but I like Traktor fanboys as well.

But which one is best? There's only one way to find out...

Harry-Hill-Fight-AP-WDC5.jpg

[Stewe]

How about arm wrestling?

[synthet1c]

dammit! i cant find any good animated gifs