flight cases...

[charo]

nice case! what model is that? by the looks of it, there's probably enough room to add my audio 1 soundcard and a hardrive (stands vertically). Just have to cut out the foam.

Now only if I could somehow get it to have a built in laptop stand that would be the *ish!!

i'd like to know what case that is too, it looks great, is that the one on amazon for like $40?

[JesC]

Here you go. http://www.marathonpro.com/marathonmaluc.html

here is the pix...its too big so here is the link:

http://us.st12.yimg.com/us.st.yimg.c...4_2021_8752076

[EYENSEE]

Here you go. http://www.marathonpro.com/marathonmaluc.html

here is the pix...its too big so here is the link:

http://us.st12.yimg.com/us.st.yimg.c...4_2021_8752076

cool, i think this one:

http://www.marathonpro.com/mama1.html

might be the one i'm looking for. I did some of the measurements and it fits

case (inches): 20 wide x 22 deep x 11.5 high (exterior)

the vestax itself is (inches) 14 wide x 10 deep x 2 high

gives enough room to fit my lacie harddrive and audio1 kontrol soundcard



so when you bought your case, the foam that came with it, were there any instructions on how to cut it out? (lol, sounds like a dumb question, but I've never done it before...) any tips?

[JesC]

The foam was included...and it pre-cut. all you have to do is rip out the section that you dont need. its like playing tetris (backwards tho)

What I did with my VCI is I placed it near the bottom (as seen on the picture) and the flipped the vci upside down to place thumb tacks @ each corner. Once I center it, i ripped out that section but I left 1" on eachside top/bottom - left/right so the vci could fit nice and snug, i ended up going with 1/2" all around.

[BentoSan]

for the lapto stand make a pvc stand is cheapp

here is the link http://www.djtechtools.com/2008/02/1...tand/#more-215

DIY goodness
Someone came up with the cool idea of installing LED lighting in the tubing which i think is a pretty cool idea.