Originally Posted by
Zac Kyoti
Cool. Glad you got it to work! That's what I was saying about the send monitor state needing to be an IN. As for the knobs, the message you need to send the APC is a one time thing, so you just need to figure out what button(s) you hit when you need the rings to change. That button will send an output message. Remember I said the CC# you need to send is the the CC# of the knob plus 8, so for example, the knob that is normally CC10 would be CC18. The range 01-03 initializes the behavior.
So don't have that knob assigned with an output of CC+8, have a button send an output to the knob's CC+8. Does that make sense?
As an aside that you may run into - I've noticed something weird about Traktor output commands vs. the APC. If you have outputs assigned normally to the knobs: that will work fine with fx outputs, but the APC doesn't handle outputs from Gain/Eq right. This may be a Traktor bug. So the take away is that if you can avoid having Gain/Eq have an output, do it. The Fx should be good, and you can put that to good use by using the APC's bank memories (track selection buttons) for various fx units. Remember too, that you want the leds to update when you change banks, so assign regular outputs to the knobs you use in each bank.
Bookmarks