4 Banks mapping

[Stewe]

Simply need more options on your controller or wish to push your Traktor mapping potential to the max? This is a mapping technique you've been looking for.

Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 1
Add out modifier #1
Controller range - 1 to 1

Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 2
Add out modifier #1
Controller range - 2 to 2

Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 3
Add out modifier #1
Controller range - 3 to 3

Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 4
Add out modifier #1
Controller range - 4 to 4

4 bank mod.tsi

[iona]

is it possible to map them blinking? i had the idea to map a beatphase monitor out to each button, but since its connected to a specified deck or focus it won't work...

[Stewe]

Hey iona, what controller do you map to traktor? Sure, it is possible.

[iona]

oh i forgot - the xone k2. at the moment i mapped four beatphase monitors per button (A,B,C,D) since at least one deck is running - but i think its not a clean solution.

[Stewe]

You should map all four deck's phase monitors to every each four buttons for that scenario.

[iona]

ok, thx for the advice. you mean the normal phase instead of the beatphase?
had hoped that there is a better solution. but somehow i get used to map x commands for one function.

[Stewe]

No, I meant of beat phase monitor there also. Until Tractor can offer some kind of optional state blink command we must satisfy with what we got

[iona]

ok - than i've done correctly. thx again!

[Stewe]

I'm glad that helped.

[Stewe]

Here is one short demo video: