a newer version of this mapping is now available in this thread:
http://www.djtechtools.com/forum/showthread.php?t=11330
a newer version of this mapping is now available in this thread:
http://www.djtechtools.com/forum/showthread.php?t=11330
Last edited by EanGolden; 02-15-2010 at 11:01 PM.
nice first one here!!! I hope this tsi loads for me!!
Thanx Ean
SS
2x Technics M5G :: Traktor 3.4/PRO2 :: Vestax VCI-100
M-Audio Ultra :: Macbook Pro 13" 2010
OK so big fix I think that needs to be made :
Have the Slice + Jogwheel reset each time!
I know that in the beta thats how it was, why not now?
SS
2x Technics M5G :: Traktor 3.4/PRO2 :: Vestax VCI-100
M-Audio Ultra :: Macbook Pro 13" 2010
Thank you so much Ean!!
VCI-100 Arcade (3_0 Mapping), Audio 4DJ
I noticed the Low/High Cut Filter Knobs stop working when FX Mode is "on". Is this because we don't have any FX module available in order to filter while FX mode is enabled or is it a bug?
Bug or not, I'd suggest the following mapping while FX mode is "on":
- moving the FX parameter assigned to the volume faders to these knobs in order to allow volume control while on FX mode
OR
- moving the FX parameter assigned to the pitch fader to these knobs in order to be able to add transposing to our FX performance.
Last edited by dros; 02-02-2010 at 03:08 AM.
Itīs working for me now! Had two versions of Traktor installed and kept opening the old 1.2.2 version so it didnīt import the tsi. very very
New version new tsi everything fine now i only have to start playing with it.
things learned
the 3.0 setup defenitely only runs with Traktor 1.2.4.
you can have 2 working versions of Traktor on a mac wich can come handy with future updates
i should remember where i put things before trying to upgrade
Found out that somehow the XFade had the same controler set as the DRY/Wet knob on Fx1
Deleting the Control for dry/wet fixed the prblm
I think i found a next thing thereīs that problem that on Deck A/D u have to press sync twice to sync as described earlier by smbdy in the old 3.0 thread.
I suppouse this is because the Sync Out on Deck A (Ch2 Note A#4) misses isīt second modifier i added M4=0 as second Mod and it seems to work now.
Hope this is a solution and doesnīt bring up other prblms will keep on checking
I think there is something went wrong with zipping...
The solution:
1. download the file from Ean
2. extract the File in the zip (it has no extension!)
3. now you can open the extracted file with winrar (or add extension .zip)
now you should have 2 directoris one for mac an one for win...
everythin should work now!
but only if you use traktor 1.2.4 - if you have an oder Version you could not import controller settings!
|
Bookmarks