-
Tech Wizard
VCI 100 midi note problem / firmware update
hi.
i have some questions on the midi-signals coming out of the vci.
In an ( earlier post ) i asked for help, but over 100 members didn't seem to know what to say.
anyway... i experimented with bomes midi translator and noticed that the firmware 1.3 (and 1.2) send some similar notes for each button on the sites of deck a and deck b.
every button on site of deck A sends out: 90 6B 7F => note B7 active, with vel.127
every button on site of dcck B sends out: 90 6C 7F => note C8 active, with vel.127
would bother much, if this wasn't the same signals which the "three-state-button" of the fx-section sends.
B7 on state:"led on top", and C8 on state:"led on bottom"
does anybody know why the vci is doing this ? is there a reason i don't see?
The two midi notes do NOT effect the buttons and knobs of the fx-section. These are hardwired. they change their notes with the button-state (top,middle,bottom = 3 different sets of notes).
if ANYBODY has ANY IDEA, I'd really appreciate any suggestions for workarounds. Even help for rewriting the firmware. which, i guess, shouldn't be too hard, hence i only need to delete some signals ?!?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks